Our Surface-Mount Device (SMD) Simon Says kit is a great challenge to anyone with intermediate skills at soldering resulting in a pretty fun toy that you can be proud to say ldquo;I made this!rdquo; We want to up the ante and make you more proficient in all soldering forms, we want to teach you how to stencil and reflow SMD parts! If you donrsquo;t have the correct resources it could be quite difficult, we understand that, so we will give you everything you need (including step-by-step instructions) to complete this Simon.
The Surface Mount Stenciling version of the Simon Says Kit includes everything that the original kit does as well as the basic stenciling tools you need to put it together! This is a great kit for anyone who knows how to solder SMD or teaching someone to solder SMD.
Again, this kit is considered an intermediate kit for people who have soldered before and wish to learn how to reflow surface mount components. Donrsquo;t worry, wersquo;ve added extras of the small components to help you out if you misplace a super tiny resistor.
Note: You will need a heat source for reflowing the solder paste. A Heaterizer, hair dryer, hot-air rework station, hot plate, etc should work.
Note: Brought back for only a limited time. We found some remaining stock and decided to make what little we had left available to those who may want it.
Through-hole components:
- 1 x ATmega328 based Simon PCB (w/outer frame)
- 2 x AA Battery Clips
- 2 x Slide switches
- 4 x LED (Yellow, Blue, Red, Green)
- 4 x Screws
- 4 x Plastic Standoffs
- 1 x Rubber 4-Button Pad
- 1 x Button Pad Frame
SMD components:
- 4 x 330 Ohm Resistors
- 1 x 10k Ohm Resistor
- 1 x 47uF Capacitor
- 1 x 10uF Capacitor
- 2 x 0.1uF Capacitor
- 1 x MBRA140 Diode
- 1 x 22uH Inductor
- 1 x NCP1402 SOT-23-5 IC
- 1 x ATmega328 TQFP IC (Pre-Programmed!)
- 1 x Buzzer
Tools:
- 1x Tweezers
- 1x Simon Stencil
- 1x Card (Squeegee)
- 1x Solder Paste (Lead-Free)
Documents: