Abbiamo aggiornato la nostra informativa sulla privacy.
Se vuoi saperne di più visualizza il dettaglio della nostra informativa sulla privacy.
Questo sito utilizza i cookies di profilazione.
Proseguendo la navigazione acconsenti all'uso di tutti i cookies.
Se vuoi saperne di più visualizza il dettaglio della nostra Cookies Policy.
A mini class D with AGC and I2C control Yes please! This incredibly small stereo amplifier is surprisingly powerful. It is able to deliver 2 x 2.8W channels into 4 ohm impedance speakers (@ 10% THD) and it has a i2c control interface as well as an AGC (automatic gain control) system to keep your audio from clipping or distorting.
If you don#39;t want to use I2C to control it, it does start up on with 6dB gain by default and the AGC set up for most music playing. We do suggest using it with a microcontroller to configure it, however, since its quite powerful. Settings are not stored in the chip, so you#39;ll need to adjust any gain amp; AGC amplification settings every time the amp is powered up.
Inside the miniature chip is a class D controller, able to run from 2.7V-5.5VDC. Since the amp is a class D, it#39;s incredibly efficient (89% efficient when driving an 8Omega; speaker at 1.5 Watt) - making it perfect for portable and battery-powered projects. It has built in thermal and over-current protection but we could barely tell if it got hot. This board is a welcome upgrade to basic LM386 amps!
The inputs of the amplifier go through 1.0uF capacitors, so they are fully #39;differential#39; - if you don#39;t have differential outputs, simply tie the R- and L- to ground. The outputs are Bridge Tied - that means they connect directly to the outputs, no connection to ground. The output is a ~300KHz square wave PWM that is then #39;averaged out#39; by the speaker coil - the high frequencies are not heard. All the above means that you can#39;t connect the output into another amplifier, it should drive the speakers directly.
Comes with a fully assembled and tested breakout board with 1.0uF input capacitors. We also include 3.5mm screw-terminal blocks so you can easily attach/detach your speakers, and some header in case you want to plug it into a breadboard. Speakers are not included, use any 4 ohm or 8 ohm impedance speakers.
Le informazioni riportate su robot-domestici.it
possono essere soggette a modifiche senza preavviso, alcune immagini sono a titolo indicativo.
Tutti i marchi citati sono di proprietà delle rispettive case e produttori.
Informazioni aziendali
ROBOT DOMESTICI SRL - Via Cornelio Labeone, 70 - 00174 Roma (RM)
Partita IVA IT15791431008 - REA di Roma n. RM 1614298
CODICE FATTURAZIONE ELETTRONICA: KRRH6B9
Tel. (+39) 06 76971136 | e-mail: info@robot-domestici.it