Abbiamo aggiornato la nostra informativa sulla privacy.
Se vuoi saperne di più visualizza il dettaglio della nostra informativa sulla privacy.
Questo sito utilizza i cookies di profilazione.
Proseguendo la navigazione acconsenti all'uso di tutti i cookies.
Se vuoi saperne di più visualizza il dettaglio della nostra Cookies Policy.
The Art Controller is a multitalented, stand-alone relay module with microcontroller based timing and logic. Easier to adjust and more versatile than most other low-cost time-delay relay modules, the Art Controller can switch AC or DC loads and is reprogrammable to handle the most specialized applications.
The Art Controller gets its name from its inspiration. It was originally suggested by San Francisco Bay Area kinetic artists Christopher T. Palmer and Nemo Gould as a stand-alone device for triggering activating electronic art pieces that need to run for a little while after a button is pressed or a coin is inserted into a slot. And while it can do that (very well), it can be used in countless other jobs where you need to switch on (or off) an electronic load with a relay and timer.
Hardware features:
Recommended load rating: 24 V DC/40 VAC, 5 A (10 A, normally-open, only).
Screw terminals for relay contacts.
DIP switches to set timing.
Power indicator and relay state indicator LEDs.
On-board 5 V regulator; runs from 7-15 V DC, or can be run from 5 V directly.
Screw terminals for trigger and input power. Location for optional DC power barrel jack.
Pre-programmed AVR Microcontroller (Atmel ATtiny2313A), with 6-pin programming header
Standard timing features:
Time delay can be set from 1 second to 31 hours.
Time delay is set by DIP switches; no need to guess and check timing with an adjustment dial.
Can be triggered by any low-going signal, or external button, switch, or coin acceptor.
Versatile operating modes:
Can be run as a one-shot or repeating (automatic cycling) timer.
Can be configured to cancel the trigger if a second trigger input is received.
Can be set to automatically trigger at power-on.
And, that#39;s just with the standard firmware. You can customize every bit of the Art Controller#39;s behavior to your heart#39;s content by reprogramming the microcontroller.
Le informazioni riportate su robot-domestici.it
possono essere soggette a modifiche senza preavviso, alcune immagini sono a titolo indicativo.
Tutti i marchi citati sono di proprietà delle rispettive case e produttori.
Informazioni aziendali
ROBOT DOMESTICI SRL - Via Cornelio Labeone, 70 - 00174 Roma (RM)
Partita IVA IT15791431008 - REA di Roma n. RM 1614298
CODICE FATTURAZIONE ELETTRONICA: KRRH6B9
Tel. (+39) 06 76971136 | e-mail: info@robot-domestici.it