Abbiamo aggiornato la nostra informativa sulla privacy.
Se vuoi saperne di più visualizza il dettaglio della nostra informativa sulla privacy.
Questo sito utilizza i cookies di profilazione.
Proseguendo la navigazione acconsenti all'uso di tutti i cookies.
Se vuoi saperne di più visualizza il dettaglio della nostra Cookies Policy.
PIR sensors are used to detect motion from pets/humanoids from about 5 meters away (possibly works on zombies, not guaranteed). This sensor is much smaller than most PIR modules, which makes it great for unobtrusive projects. It#39;s also fully-contained - only needs power, ground and a resistor to set the delay time - and breadboard or perfboard friendly.
Runs on 3.3V power - so make sure if you#39;re interfacing with an Arduino or other 5V chip, you power it from the 3V regulator. Digital signal output is 3.3V high/low and you can change the length of time the signal pin stays high by connecting a resistor divider to the second pin, from 2 seconds (0V) up to one hour (3.3V) - see the datasheet #39;on time#39; table for recommended resistor values.
Le informazioni riportate su robot-domestici.it
possono essere soggette a modifiche senza preavviso, alcune immagini sono a titolo indicativo.
Tutti i marchi citati sono di proprietà delle rispettive case e produttori.
Informazioni aziendali
ROBOT DOMESTICI SRL - Via Cornelio Labeone, 70 - 00174 Roma (RM)
Partita IVA IT15791431008 - REA di Roma n. RM 1614298
CODICE FATTURAZIONE ELETTRONICA: KRRH6B9
Tel. (+39) 06 76971136 | e-mail: info@robot-domestici.it